532i Elliptical Fitness CrossTrainer Assembly Guide 6
Slide the metal shaft through the lift frame. Align the holes and
insert two buttonhead screws (H). Wrench tighten.
Slide both shaft covers over the metal shaft so the ends touch
the lift frame.
Install the front lift cover. Align the mounts and engage the
side clips by pressing the front and back covers together.
Insert the four fasteners set aside in step 2. Wrench tighten
using the long-handle ⁵⁄₃₂-inch hex key.
Attach the magazine rack. Align the tabs and apply downward
pressure and lightly squeeze the magazine rack and back
cover together. An audible click is heard when the magazine
rack is secured properly.
Shaft
cover
To Next Page
Loading...
