To complete the cover assembly:
1. Secure each side cover using one screw .
Figure 15
2. Position the display front cover so that the two internal hooks are engaged
with the inside bottom of the side covers.
Figure 16
3. Using both hands, pull the front cover forward to snap it into place.
Figure 17
4. Press the front cover upward to close the gap between the covers and
secure it using two screws
.
Note If the clip nuts
are missing from your front cover, use the extra
clip nuts included in your hardware kit.
Figure 18
5. Position the top cover so that the two top latches fit into the top of the side
covers. Rotate it downward into place.
Figure 19
6. Secure it using one screw
.
Figure 20
To complete the console installation, refer to the installation guide
shipped with your console.
10
To Next Page
Loading...
