There are latches on the plastic covers that must be engaged to ensure a good
fit. Review the follow procedure before starting the cover assembly.
To attach the side covers:
1. Position one of the side covers against the console frame with its ramp latch
setting on top of the ramp and its wing edge fitted into the arm as shown
below.
Important Flex the plastic to fit it against the frame. DO NOT pinch or crush
the cable during assembly.
Fig
ure 11
2. Position the second side cover against the console frame.
3. Identify where the covers join on the bottom and press upward to snap the
internal latch together.
Fig
ure 12
4. Press the top of the covers together to engage the top internal latch.
Fig
ure 13
5. Snap a pivot bracket onto the boss of each side cover and then attach eac
h
b
racket using two screws
.
Note The bracket should fit tightly against the assembly.
Fig
ure 14
9
To Next Page
Loading...
