Assembling the Treadmill 29
4. Adjust the rear feet as needed.
Figure 16: Leveling foot adjustment
5. Repeat steps 1 through 4 until the treadmill is level.
6. If necessary, adjust the rear feet so that the user’s weight
is distributed evenly on the treadmill.
Plugging In the Power Cord
CAUTION: Use the supplied power cord. Do not remove or
otherwise bypass the 3-prong plug with an adapter to use a
non-grounded outlet. Do not plug the unit into a power
transformer in an attempt to adjust the voltage requirements.
Failure to follow these instructions might damage the unit and
void the Precor Limited Warranty.
After assembly is complete, plug the power cord into an
appropriate outlet.
Important: The treadmill requires a 20-amp dedicated branch
circuit. Refer to Treadmill Grounding Instructions.
Breaking in the Equipment
Precor equipment does not require an actual break-in period.
However, moving components such as belts, gears, and
bearings can settle while the equipment is being stored or
shipped. This can cause the equipment to operate with a
small amount of roughness or noise when it starts up for the
first time.
The equipment usually returns to smooth operation after a
day or two of normal use. If it does not, contact your dealer
for assistance. For more information, refer to Obtaining
Service.
To Next Page
Loading...
Need help?
General
