Precor SPINNER RIDE - Page 34

14. Adjust the chain tension to specification, go to "Chain Drive Tension Adjustment" on
page11
15.
Tighten the left and right axle nuts , torque to 29.5 ft-lbs (40 Nm).
16.
Reinstall the rear chain sprocket finger guard , secure with two fasteners using a 5
mm hex key.
17. Replace front and rear chain guard covers in reverse order, see "Belt/Chain Guard
Cover Replacement" on page18.
18. Verify that the brake pad is centered on the flywheel and operating correctly.
19. Verify the bike operation per "Operation Verification Checklist" on page7 and return to
service.
.See Also
"Replacement Procedures" on page16
29