Precor Vitality Selectorized Series - Attach the Seat Pad, Back Pad, and Lumbar Pad

Vitality Series Selectorized Line Abdominal / Back Extension Assembly Guide: Assemble the Equipment 12
Attach the Seat Pad, Back Pad, and Lumbar Pad
1. Attach the seat pad to the seat frame using:
2 – M10 x 75 mm hex head bolts
2 – 11 mm flat washers
Note: The round end of the pad should face forward.
Figure 14: Seat pad attachment
2. Attach the back roller pad to the movement arm. Remove the end section of
the back roller pad and shoulder strap tube by detaching:
1 – M8 x 70 mm hex head bolt
2 – 9 mm flat washer
1 – M8 nut
Slide the back roller pad over the end of the movement arm, then replace the
fasteners you just removed.
Figure 15: Back pad attachment