starts. If the bin sensor shows full and the unit is powered down, when the
unit‟s power is restored, the unit automatically starts when the bin sensor
shows not full.
4.2.2 Ultasonic Sensor
The Ultrasonic sensor – is the original sensor designed to work with the
A5000 System. The AirSpeed™ SMART V3 was enhanced to include the
capability to use this sensor. The sensor has a required adjustment
procedure for configuring the sensor. Please read the
20120613 US Sensor
Training
document on the Pregis Tech Portal. The sensor is designed to turn
ON when there is material present and OFF when there is no material.
Position the Ultrasonic sensor over the material. Follow the instructions in
Section 3 for selecting the US sensor. Set the timer to 0:00 and press Play.
When Play is pressed, if the bin sensor shows empty the unit starts and
continues until 1) play is pressed or 2) bin sensor shows full. When the bin
sensor shows empty the unit starts again and the cycle repeats. When the
play button is pressed, if the bin sensor shows full, the unit waits until the
sensor shows empty then starts. If the bin sensor shows full and the unit is
powered down, when the unit‟s power is restored, the unit automatically
starts when the bin sensor shows not full.
To Next Page
Loading...
