SECTION 6 – LOADING NEW SOFTWARE
6.1 Introduction
At power-on the AirSpeed™ Smart‟s Bootloader executes. This bootloader is
used to update the unit‟s application software. If the bootloader does not
detect new software, the existing application software is started.
6.2 Procedure
1. The new software is stored on a USB memory stick.
2. Power off the unit
3. Open the unit and install the USB memory stick into the control board.
4. Install jumper JP2
5. Power on the unit.
6. After a few seconds the bootloader recognizes the USB stick and loads
the new software.
7. After software is loaded, it is started and enters the unit „burn-in‟.
8. Power off the unit
9. Remove jumper JP2
10. Remove the USB memory stick
11. Power on unit and verify that the unit is operational. That is, it is not
in unit „burn-in‟.
Notes:
You must install both the USB memory stick and JP2 as the bootloader looks
for the USB memory stick only if JP2 is installed.
To Previous Page
Loading...
