5.3.6 Sample Display – Run
A sample „run‟ display is shown in
Figure 7
. The display shows the sealer
temperature and the time remaining in the „run‟ state
Figure 7 Sample Running Display
5.4 Selecting between „Operational‟ and „Burn-in‟ Modes
The jumper plug JP2 on the cpu board is used to select between
„Operational‟ and „Burn-in‟ modes. When the two pins of JP2 are shorted,
„Burn-in‟ mode is selected. When open the „Operational‟ mode is selected.
NOTE: This jumper is also utilized to select which bin sensor is active during
„Burn-in‟ mode only.
SEALER TEMP: 215.5
RUN STATE 420
To Next Page
Loading...
