Premier WP5-50 - Final Polishing Filter Installation

Page 11
Thread the larger (3/8”) white plastic connector into the inlet end
of the nal lter (ow arrow on lter points away from the 3/8”
connector - see picture).
Step 23 Thread the smaller (1/4”) white plastic connector into the outlet
end of the Final Filter and tighten (ow arrow on lter points to the
1/4” connector - see picture).
Step 24
Insert the 1/4” blue tube attached to the faucet into the outlet of the lter and tighten plastic
nut securely. The ow arrow should be pointing toward the faucet. Insert the 3/8” blue tube
attached to the module into the 3/8” inlet white connector on the in-line Final Filter. T
ighten
the white compression nuts with an adjustable wrench.
Step 25
Remove the seal caps from both ends of the nal lter. Step 22
Do not overtighten these connectors as it may damage them
or the nal lter.
Note:
Final Polishing Filter Installation
Flow
1/4”
3/8”
A connection to a refrigerator / ice maker may be tee’d into this blue tube and should
be spliced in between the nal lter and the RO faucet.
Note: