PrepPal PPM 60 - Installation Guide; Unpacking and Initial Setup



5
Installation
UnpackingandInitialSetup: 
Immediatelyafterunpackingthemixer,checkforpossibleshippingdamage.Ifthismachineisfound
tobedamagedafterunpacking,savethepackagingmaterialandcontactthecarrierwithin15daysof
delivery.Safetyunpackingstepasbelowphotos:
Step01:Carefullyremovethepackagematerialfromequipment. 
Step02:Takeawaythetrailer.
Step03:Anticlockwiserotatethehandletolowdownthebowlandunlockit.
Step04:Takeawaythebowl.
Step05:FindthewrenchfortheM12bolt.
Step06:UnscrewtheM12boltsinsidethefourlegs.
Step07:Puttwoforksintothebottomofmachineandprotectthebottom.
Step08:Slowlyliftthemixermachineupabout4”fromthepallet.
Step09:Pullpalletawayfromthebottomofmixerfeet.
Step10:Declineforklift,standmixerontheground.


Placethemixeronasolid,levelsurfacewithsufficientspacearoundmixertoallowforthesafecleaningand
service.
Plugonlyintogroundedelectricaloutletsmatchingthenameplateratedvoltage.

Note:Donotplugmixerintoapowerstripormulti‐outletpowercord. 