EasyManua.ls Logo

PrepPal PPM 60 - CRAWL for Speed Handle Switch; Setting Timer; Using the Attachment Hub

PrepPal PPM 60
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
CRAWLforspeedhandleswitch

SettingTimer
UsetheAttachmentHub
TimedOperation: PresstheredbuttontotheTIMERside.Tosetthe
timefortheappropriatemixingtime,turnthetimerknobina
clockwisedirectionatthepositionbetween0to30,toget
mixingtimebetween0minsto30mins.
Non‐TimedOperation: PresstheredbuttontotheNON‐TIMEside
tosetthemixerfornon‐timedoperation.
NOTE: Heavyloadsshouldnotbemixedlongerthanfifteen(15)minutes
atthissettingwithoutanequalamountofresttimeforthemixer. failure
toadheretotheseinstructionsmaycausethemixertoautomaticallyshut
offduetooverloading.
Neverputyourhandintothefeedchutewhenusingamixerattachment.
OnlyoperatetheattachmenthubinMANUALmode.
DONOTattempttomixingredientsinbowlwhileusingthehub.
MixermustbeOFFbeforeinstallingattachment.
DoNOTuseattachmentswhilemixing.
1.Loosenandremoveattachmenthubfastenscrew.ThenRemovehubcover.
2.Lubricateattachmentshaftwithafoodqualitygreaseormineraloil.
3.Insertattachmentshaftintohubmakingsuretolineupthealignmentpin
withhubhole.
4.Tightenthumbscrewbackintohubandsecurelytightenit.
5.Selecttheappropriatespeedsettingbyliftingorloweringspeedcontrol
lever.
6.Usetheuntimedoperationdescribedonthepreviouspagetoadjusttimer.
7.PressthegreenSTARTbuttonlocatedonthecontrolpanel.
RecommendedSpeedwhileusingattachments:
Attachment: RecommendedSpeed:
MeatGrinder 1only
NOTE:Makesurebowlisupandbowlguardisclosed.Mixerwillnotstartif
bowlandbowlguardarenotintheproperoperatingposition.
Ifitisdifficulttoswitchthespeedhandleatrightposition,youcanpress
thebuttonof(LAMP&CRAWL)transitorily.
Pressthebuttonof(LAMP&CRAWL)transitorilycanlettheplanetary
shaftrotatebyalittleangle,sogearscanocclude.
Canpressthebuttonof(LAMP&CRAWL)transitorilyforseveraltimes
untilthespeedhandlecanbeswitchtorightposition.

Related product manuals