Prestige APS-922E - System Status, Compliance, and Programming; System Functions at a Glance; FCC Compliance and Warnings

128-9363
19 of 24
Page 19
APS 922E
SYSTEM FUNCTIONS AT A GLANCE
DASH LED INDICATORS
RAPID FLASHING = PASSIVE ARMING/ACTIVE
REARMING
SLOW FLASHING = ARMED
OFF = DISARMED
ON SOLID = VALET MODE
3 FLASH...PAUSE = INTRUSION ZONE 3
2 FLASH...PAUSE = INTRUSION ZONE 2
1 FLASH...PAUSE = INTRUSION ZONE 1
SIREN CHIRP INDICATORS
1 CHIRP * = ARM
2 CHIRPS * = DISARM
3 CHIRPS = ARM / DOOR OPENED
4 CHIRPS = DISARM / INTRUSION
* These chirps are optional, and can be de - activated.
PARKING LAMP INDICATORS
1 FLASH = ARM
2 FLASHES = DISARM
3 FLASHES = DISARM / INTRUSION
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference that may
cause undesired operation.
Warning!
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modications to this equipment. Such modications could void the user’s
authority to operate the equipment
PROGRAMMED TRANSMITTER NOTIFICATION (PTN)
Whenever the ignition is turned on, providing the system is disarmed, the unit's LED will
report the number of transmitters programmed into the system. This safety feature will
alert you if an unauthorized transmitter has been programmed into your vehicle's security
system without your knowledge. Typical from the factory, there will be a 2 ash, pause,
repeated 3 times indicating that two transmitters are programmed into the system. If you
note additional ashes, there may have been an additional transmitter added without your
knowledge or authorization. If you notice a change in the transmitter LED report pattern,
you can correct this by looking up how to erase and reprogram your transmitters found in
the transmitter programming guide. This reprogram operation will erase all unauthorized
or unwanted transmitters.