128-9363
16 of 24
Page 16
ADDITIONAL REMOTE FEATURES:
The two way remote control unit allows you to access status
information from the vehicle, check temperature, light the display,
toggle the transmitter from beep tones to vibrate mode, initiate
daily start timer, and temperature start. Selection of these and
other features are shown below:
NOTE: Transmitter must be within operating range of the vehicle,
approximately 1000 ft.
Check Vehicle Status
Press the lock+key+option buttons simultaneously for 1 second.
The vehicle's alarm will display the systems current status.
Light The Display
Press and release the "F" (Function) button one time. The display
will illuminate for 10 seconds.
Vibrate Or Tones
Press the "F" and unlock buttons simultaneously to toggle this feature on and off.
Daily Start Timer (Only available on certain remote start units)
24 Hour Start Timer Standing at the vehicle at the time you want it to
start, press the option + lock buttons simultaneously for 1 second. The
transmitter will beep and display the 24 hr timer. This is the time the
vehicle will start when you follow the exit procedure. In other words, if you want
the vehicle to start 6AM, at 6AM of any morning, standing at the vehicle, press
and hold the option + lock buttons until you hear a beep and the 24 hr timer is
displayed. This establishes a starting time.
The Remote Start unit will start at the prescribed time once only. This function
must be activated by following the procedure below each time you want the vehi-
cle to start at the prescribed time.
To activate this function,
(a) Turn the ignition switch off.
(b) Within 10 seconds of step (a), depress and hold the brake pedal, while press-
ing the key icon transmitter button 2 times.
(c) the unit will emit 2 chirps, the transmitter will beep and the start timer icon on
the display will remain on.
The vehicle will start at the set time.
To toggle this feature off, press the option + lock buttons simultaneously until a
beep is heard and the 24 hr timer turns off.
NOTE: The unit will start once and run for the prescribed time. If you require
more frequent starting please refer to auto start up timer mode shown
earlier in this guide.
NOTE: To ensure accurate 24 Hour Start up, it is advisable to reset the start time
periodically as time may drift slightly each day.
To Next Page
Loading...
