27
Go-Go Ultra www.pridemobility.com
Figure 10. Seat Height Adjustment
UPPER SEAT POST
LOWER SEAT POST
DETENT PIN
VII. COMFORT ADJUSTMENTS
TILLER ANGLE ADJUSTMENT
Your scooter is equipped with an adjustable pivoting tiller
that you can position to maximise your ergonomic comfort.
1. Turn the tiller adjustment knob anticlockwise to loosen
the tiller. See figure 9.
2. Move the tiller to a comfortable position.
3. Turn the tiller adjustment knob clockwise to secure the
tiller in position.
NOTE: In order to lower the tiller to the
scooter deck, you must first remove the
seat.
SEAT ROTATION
The seat lock lever is located at the bottom of the right side
of the seat. The lever allows you to lock the seat into one of
four positions: forward, rearward, left, and right.
1. Pull up on the seat lock lever to unlock the seat.
2. Rotate the seat to the desired position.
3. Release the seat lock lever to lock the seat securely in
place.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See figure 10.
1. Remove the seat from your scooter.
2. Use the attached ring to pull and remove the detent pin
from the lower seat post.
3. Raise or lower the upper seat post to the desired seat
height.
4. While holding the upper seat post at that height, align the
adjustment holes of the upper and lower seat posts.
5. Fully insert the detent pin.
6. Reinstall the seat.
Figure 9. Tiller Adjustment
TILLER
ADJUSTMENT
KNOB
WARNING! Remove the key from the key switch before adjusting the tiller or the seat.
Never attempt to adjust the tiller or the seat while the scooter is in motion.
ARMREST WIDTH ADJUSTMENT
The armrest width can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs at the back of the seat frame.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs as required.
The armrests can also pivot upward to aid in getting onto and off of your scooter.
To Next Page
Loading...
Need help?
General
