Legend XL www.pridemobility.com 41
1
Varies with user weight, terrain type, battery amp-hour (Ah), battery charge, battery condition, and tire
condition. This specification can be subject to a variance of (+ or -) 10%.
2
Tested in accordance with ANSI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from
theoretical calculation based on battery specifications and drive system performance. Test conducted at
maximum weight capacity.
3
Due to manufacturing tolerances and continual product improvement, this specification can be subject to a
variance of (+ or - ) 3 %.
4
AGM or Gel-Cell type required. See IV. “Batteries and Charging.”
5
Battery weight may vary based on battery manufacturer.
NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO 7176
series EN12184 standards. All specifications subject to change without notice.
Model Number SC3450
Maximum Allowable Incline 150 lbs (68 kg) 8° (14.1%)
200 lbs (90.7 kg) 7° (12.3%)
250 lbs (113.4 kg) 6° (10.5%)
300-400 lbs (136-181.4 kg) 5° (8.7%)
Overall Length
3
52 in. (132 cm)
Overall Width
3
24 in. (61 cm)
Total Weight 283 lbs. (128 kg)
Total Weight Without Batteries 207 lbs. (94 kg)
Heaviest Piece When Disassenbled Rear Section: 82 lbs. (37 kg)
Turning Radius
3
65 in. (165 cm)
Speed (Maximum)
1
5.8 mph (9.33 km/h)
Range Per Charge
1
,
2
(With NF-22 batteries) Up to 30 miles (48.28 km)
Ground Clearance
3
4 in. (10 cm)
Weight Capacity
400 lbs. (181 kg)
Standard Seating Type: CRS deluxe reclining highback with headrest
Weight: 45 lbs. (19 kg)
Material: Grey Vinyl
Dimensions: 18 in. (45 cm) overall width
18 in. (45 cm) effective depth
20.5 in. (52 cm) height (usable)
27-29 in. (68.5-73.7 cm) with headrest
Drive System Rear-wheel drive, sealed transaxle, 24-volt DC motor
Dual Braking System Regenerative and Electromechanical
Tires Type: pneumatic front and rear: 4 in. x 13 in. (10 x 33 cm)
Battery Requirements
4
Two 12 volt, deep cycle, AGM or Gel-Cell type recommended
Size: 55 AH, NF-22
Weight: 38 lbs. each (17 kg)
Battery Charger Off-board
APPENDIX I - SPECIFICATIONS
To Next Page
Loading...
