What to do if my Pride Mobility scooter does not move when I press the throttle?
If your scooter doesn't move when you press the throttle control levers, pull back on the manual freewheel lever, turn the scooter off, and then turn it back on to return to normal operation.
What to do if the main circuit breaker repeatedly trips on my Pride Mobility Legend XL Scooter?
If the main circuit breaker repeatedly trips, charge the scooter’s batteries more frequently. Additionally, you can have both of your scooter’s batteries load tested. If the main circuit breaker continues to trip repeatedly, contact your authorized Pride Provider for service.
What to do if the battery voltage is too low on my Pride Mobility Legend XL?
If the battery voltage is too low to operate the scooter or the charger is operating, charge the batteries or unplug the charger power cord from the electrical outlet.
What to do if my Pride Mobility scooter was left in free-wheel mode?
If your scooter was left in free-wheel mode, which causes a brake fault, turn the scooter key to the “off” position, then push the manual freewheel lever to the drive position, and restart your scooter.
What to do if my Pride Mobility Legend XL is operating with the charger attached?
If your scooter is operating with the charger attached, unplug the charger power cord from the off-board charger port.
What to do if the motor is disconnected on my Pride Mobility Legend XL?
If the motor is disconnected, check all connections to the motor.
Explains symbols and general safety warnings for scooter operation.
Detailed description of the tiller console and its functions.
Reading battery levels and general charging precautions for the scooter.
Tips for battery life, types, and replacement instructions.
Interpreting error codes and performing initial troubleshooting steps.
General| Ground Clearance | 3.5 inches |
|---|---|
| Overall Width | 25.5 inches |
| Seat Width | 20 inches |
| Charger Type | Off-board |
| Drive System | Rear-wheel drive |
| Armrests | Yes |
To Next Page