EasyManua.ls Logo

Pride Mobility OUTBACK - New Battery Break-in and Life; Public Transportation with Scooter

Pride Mobility OUTBACK
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
Outback www.pridemobility.com
IV. BATTERIES AND CHARGING
Why do my new batteries seem weak?
Deep-cycle batteries employ a different chemical technology than that used in car batteries, nickel-cad-
mium batteries (nicads), or in other common battery types. Deep-cycle batteries are specifically designed
to provide power, drain down their charge, and then accept a relatively quick recharge.
We work closely with our battery manufacturer to provide batteries that best suit your scooter’s specific
electrical demands. Fresh batteries arrive daily at Pride and are shipped fully charged to our customers.
During shipping, the batteries may encounter temperature extremes that may influence their initial perfor-
mance. Heat diminishes the charge on the battery; cold slows the available power and extends the time
needed to recharge the battery.
It may take a few days for the temperature of your scooter’s batteries to stabilise and adjust to their new
room or ambient temperature. More importantly, it takes a few charging cycles (a partial drain followed
by a full recharge) to establish the critical chemical balance that is essential to a deep-cycle battery’s peak
performance and long life.
Please follow these steps to properly break in your scooter’s new batteries for maximum efficiency and
service life:
1. Fully recharge any new battery prior to its initial use. This initial charging cycle brings the batteries up
to about 88% of their peak performance level.
2. Operate your new scooter in familiar and safe areas. Drive slowly at first, and do not travel too far from
your home or familiar surroundings until you have become accustomed to your scooter’s controls and
have properly broken in your scooter’s batteries.
3. Fully recharge the batteries. This recharge should bring the batteries up to about 90% of their peak
performance level.
4. Operate your scooter again.
5. Fully recharge the batteries again.
6. After four or five charging cycles, the batteries are able to receive a charge of 100% of their peak
performance level and are able to last for an extended period of time.
How can I ensure maximum battery life?
Fully charged deep-cycle batteries provide reliable performance and extended battery service life. Keep
your scooter’s batteries fully charged whenever possible. Batteries that are deeply discharged, infrequently
charged, or stored without a full charge may be permanently damaged and cause unreliable performance
and limited service life.
For prolonged storage, you may wish to place several boards under the frame of your scooter to raise it off
the ground and take the weight off the tyres. This reduces the possibility of flat spots developing on the
areas of the tyres contacting the ground.
What about public transportation?
If you intend to use public transportation while using your scooter, you must contact the transportation
dealer in advance to determine their specific requirements.

Related product manuals