43
Pathrider www.pridemobility.com
APPENDIX I - SPECIFICATIONS
Model Number 3-wheel: SC610; 4-wheel: SC710
Class of Use B
Maximum Safe Slope 14.1% (8°)
Maximum Climbing Ability 14.1% (8°)
Maximum Obstacle Climbing Ability 5 cm (2 in.)
Colours Red, Blue
Overall Length
4
3-wheel: 116.84 cm (46 in.); 4-wheel: 119.38 cm (47 in.)
Overall Width
4
56.5 cm (22.25 in.)
Total Weight Without Batteries 3-wheel: 59.2 kg (130.5 lbs.); 4-wheel: 62.36 kg (137.5 lbs.)
Heaviest Piece When Disassembled 3-wheel: Front Section (24.72 kg/54.5 lbs.)
4-wheel: Front Section (26.3 kg/58 lbs.)
Turning Radius
4
3-wheel: 109.855 cm (43.25 in.); 4-wheel: 137.16 cm (54 in.)
Speed (Maximum)
1
8.85 km/h (5.5 mph)
Range Per Charge Up to 25 km (15.5 miles)
(Theoretical value based on Test Standards)
1,2
Range Per Charge Up to 40 km (25 miles)
(Value based on Straight-line Test Simulation)
1,3
Ground Clearance
4
7.62 cm (3 in.)
Weight Capacity 158.75 kg (350 lbs.)
Standard Seating Type: Foldable Moulded Plastic
Weight: 12.7 kg (28 lbs.)
Material: Black Vinyl
Dimensions: 45.72 cm (18 in.) width; 43.18 cm (17 in.) depth
Tyres 25.4 cm (10 in.) solid
Drive System Rear-wheel drive, sealed transaxle, 24-volt DC motor
Dual Braking System Electronic, regenerative, and electromechanical
Battery Requirements
5
Two 12-volt, deep-cycle
Size: U1 (31–36 Ah) or optional 40 Ah
U1 Battery Weight: 10.43 kg (23 lbs.) each
40 Ah Battery Weight: 14.74 kg (32.5 lbs.) each
Battery Charger 5-amp, off-board
1
Varies with user weight, terrain type, battery amp-hour (Ah), battery charge, battery condition and tyre condition. This
specification can be subject to a variance of (+ or -) 10%.
2
Tested in accordance with ASNI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical
calculation based on battery specifications and drive system performance. Test conducted at maximum weight capacity.
3
Tested by Pride Mobility Products under simulated conditions; continuous straight-line driving until total battery depletion.
Test conducted at maximum weight capacity.
4
Due to manufacturing tolerances and continual product improvement, this specification can be subject to a variance of (+ or -) 3 %.
5
AGM or Gel-Cell type required. See IV. “Batteries and Charging.”
NOTE: All specifications subject to change without notice.
To Next Page
Loading...
