24 Raptor
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and
can no longer hold a charge.
DIAGNOSTIC FAULT CODES
The diagnostic fault codes for your scooter are designed to help you perform basic troubleshooting
quickly and easily. A diagnostic flash code will flash from the status LED in the event one of the conditions
listed below develops.
NOTE: Your scooter will not run unless the fault code condition is resolved and the scooter has
been turned off, then turned back on.
FAULT CODE CONDITION SOLUTION
(1)
Battery charge is low. Charge batteries as soon as
possible.
(2)
Battery charge is too low. Charge batteries.
(3)
The scooter’s battery voltage is
too high to operate the scooter,
or the charger is still connected to
the off-board charger port.
Unplug charger and/or turn key off,
then back on again.
(4)
Current limit time out. Turn the scooter off for a few
minutes, then turn your scooter
back on.
(5)
The manual freewheel lever is in
the (forward) freewheel position.
Remove the key from the key switch,
then push the manual freewheel
lever to the drive (backward)
position, and restart your scooter.
(6)
Throttle control lever not at center
position at start up.
Return the throttle control lever to
center position, turn scooter off
then back on.
(7)
Speed pot error. Contact your authorized Pride
Provider for assistance.
(8)
Motor volts error. Contact your authorized Pride
Provider for assistance.
(9)
Other internal errors. Contact your authorized Pride
Provider for assistance.
VII. BASIC TROUBLESHOOTING
To Next Page