Pride Mobility Sonic - Battery Replacement

24
www.pridemobility.com Sonic
Figure 13. Battery Harness Removal
BATTERY
HARNESSES
V. BATTERIES AND CHARGING
We work closely with our battery manufacturer to provide batteries that best suit your scooters specific electrical
demands. During shipping, the batteries may encounter temperature extremes that may influence their initial
performance. Heat diminishes the charge on the battery; cold slows the available power and extends the time
needed to recharge the battery. It may take a few days for the temperature of your scooters batteries to stabilise
and adjust to their new room or ambient temperature.
It takes a few charging cycles (partial draining followed by full recharging) to establish the critical chemical balance
that is essential to a deep-cycle batterys peak performance and long life.
What about public transport?
If you intend to use public transport with your scooter, you must contact the transportation dealer in advance to
determine their specific requirements.
BATTERY REPLACEMENT
WARNING! Battery posts, terminals,
and related accessories contain lead
and lead compounds. Wash hands
after handling.
Battery Removal
1. Remove the battery compartment lid. See figure 12.
2. Disconnect the battery harnesses. See figure 13.
3. Remove the battery pack from the scooter. See fig-
ure 14.
4. Unzip the battery pack and remove the battery or bat-
teries.
5. Disconnect the red (+) positive and black (-) nega-
tive battery leads from the battery terminals by pull-
ing them gently from the battery terminals. See figure
15.
Figure 12. Battery Compartment Lid