Travel Scooter Series 11
To engage or disengage the drive system:
1. Locate the levers on the rear section of the scooter. See fi gure 8.
2. Pull the two levers toward the rear of the travel scooter to engage the drive motors (drive mode).
3. Push the two levers toward the front of the travel scooter to disengage the drive motors (freewheel mode).
If a lever is diffi cult to move in either direction, rock your travel scooter back and forth slightly. The lever should
then move to the desired position.
WARNIN G! Do not use t he freew he e l lever ha ndle s a s t ie -dow n point s t o se c ure t his produc t .
Anti-Tip Wheels
The anti-tip wheels are an integral and important safety feature of your Travel Scooter. They are bolted to the
frame at the rear of the Travel Scooter.
PROH I BI TED! Do not remove the a nt i-t ip w he els or modify your Trave l Sc oot er in a ny w ay that is
not aut horized by your Provider.
WARNIN G! T he a nt i-t ip w heels m a y c ause inte rfere nc e w it h t he sm oot h t ra nsit ion of your Trave l
Sc oot er w he n a sc ending or de sc ending a curb. Cont a c t your a ut horize d Provider for m ore
inform ation.
Main Circuit Breaker (Reset Button)
When the voltage in your Travel Scooter’s batteries becomes low or the Travel Scooter is heavily strained because
of excessive loads or steep inclines, the main circuit breaker may trip to protect the motor and electronics from
damage. See fi gure 9.
The main circuit breaker reset button pops out when the breaker trips.
When the breaker trips, the entire electrical system of your Travel Scooter shuts down.
Allow a minute or two for your Travel Scooter’s electronics to “rest.”
Push in the reset button to reset the main circuit breaker.
If the main circuit breaker trips frequently, you may need to charge your batteries more often. You may also
need to have your authorized Provider perform a load test on your Travel Scooter’s batteries.
If the main circuit breaker trips repeatedly, see your authorized Provider for service.
II. YOUR TRAVEL SCOOTER