Pride LC-105 - Care and Maintenance; Fabric Care and Heat Source Warnings; Electronics Care and Disposal Procedures

19
VII. CARE AND MAINTENANCE
Your chair will require routine maintenance checks. You can perform some of these checks, but others may
require assistance from an authorized Provider. By following the maintenance checks in this section as
scheduled, you can help ensure your chair gives you years of trouble-free operation. If you have any questions
regarding your chair’s care, contact your authorized Provider.
FABRIC CARE
z Inspect the fabric on a regular basis for any pulls, tears, or gaps.
z Use a manufacturer-approved Crypton cleaning kit to clean the fabric on your chair. This can be used for
all fabrics. These cleaning kits are available through your authorized Provider. If a manufacturer approved
Crypton cleaning kit is not readily available, spot clean the affected area with a mild soap and water
solution and blot dry. Do not saturate the fabric.
WARNING! Fabric should not be allowed to come in direct contact with any type of heat
source (e.g., a space heater or lit tobacco products). Personal injury or re damage
may occur.
WARNING! Your Provider strongly recommends that you do not smoke lit tobacco
products while seated in or using your chair, although the chair has passed the
necessary testing requirements for smoking lit tobacco products. You must adhere
to the following safety guidelines if you decide to smoke lit tobacco products while
seated in or using your chair.
z Do not leave lit tobacco products unattended.
z Keep ashtrays a safe distance from the chair.
z Always make sure lit tobacco products are completely extinguished before
disposal.
NOTE: Prevent damage to the fabric; do not expose the chair to direct sunlight.
ELECTRONICS CARE
z Inspect all wiring harnesses to make sure they are not damaged or frayed.
z If damage is present, unplug the chair and contact your authorized Provider for service.
z Keep all electronics free from moisture and temperature extremes. Chairs are intended for indoor use
only!
WARNING! Even though the chair has passed the necessary testing requirements
for ingress of liquids, you should keep electrical connections and the external
transformer away from sources of dampness, including direct exposure to water or
bodily uids and incontinence. Check electrical components frequently for signs of
corrosion and replace as necessary.
WARNING! The external transformer should always be positioned so that the
product specication information/name plate faces down. Improper placement
may result in product or property damage.
DISPOSAL AND RECYCLING
Your chair must be disposed of according to applicable local and national statutory regulations. Contact your
local waste disposal agency or authorized Provider for information on proper disposal of chair packaging,
metal frame components, fabric, electronic components, and batteries.
WARNING! Plastic bags are a suffocation hazard. Dispose of plastic bags properly
and do not allow children to play with them.