Prins VSI-2.0 - Mounting Inlet Manifold Couplings

PAGE 10
076/2613400
Copyright © Prins Autogassystemen B.V. 2014
VW Tiguan 1.4 CAXA / CAXC
10
Mounting the inlet manifold couplings
Remove the inlet manifold. Carefully remove the heater from the manifold.
Drill 4 holes of 9 mm in the inlet manifold. Cut M10x1 thread in these holes.
Place the VSI couplings with a lock compound in the inlet manifold.
Watch out that the lock compound doesn’t come inside the VSI couplings
and place the inlet manifold back on the engine.
4x Nylon hoses : 35cm ( cut on length later )