English | 9
Notes:
• If your window opening is smaller than
the minimum length of the sealing board
assembly trim to desired length using a
hack saw.
• If your window opening is larger than the
maximum length of the sealing board
assembly use plywood or similar to ll the
gap.
Hinged Window Sealing Fabric Assembly
Installation
If your window is hinged, follow the instructions
below:
You will need:
• Hinged window fabric sealing assembly
• Sealing velcro
• A soft, clean cloth
1. Open window and clean frame and
casement surfaces of dust and particles.
2. Stick the velcro tape around the entire
window frame. Never stick to the window
seal as doing so will prohibit the window
from closing fully.
3. Stick the velcro tape around the entire
window casement (inside or outside).
Check to ensure the window can close
fully.
4. Attach side A of the sealing fabric
assembly to the velcro on the window
frame working from the centre outwards.
5. Close and open window to ensure no
fabric gets trapped.
6. Attach side B of the sealing fabric
assembly to the velcro on the window
casement working from the centre
outwards.
7. Open the window slightly and insert the
heat exhaust hose short connector into
the sealing fabric assembly securing with
the zippers around its lip.
The sealing fabric assembly is now ready for
use.
Frame
Side A
Side B
Casement
7
4 & 6
2 & 3
Hinged window sealing fabric zip
To Next Page
Loading...