15/44
3.2 Preparation
Requirements for
receiving screen data
from
GP-377R/377S/377L *1
PC in which GP-PRO/PBIII for Windows V4.0 or later is
installed. *2
Transfer cable (The following three types of cables are
available)
・ GPW-CB02 (D-sub 9-pin to the PC)
・ GPW-CB03 (USB to the PC *3)
GP430-CU02-M or GPW-SET (D-sub 25-pin to the PC)
Requirements for
converting screen data
of GP-377R/377S/377L
and transferring the
converted data to
GP4000 series
PC in which GP-Pro EX Ver.3.0 or later is installed
Transfer cable (The following three types of cables are
available)
・ A USB transfer cable (model:CA3-USBCB-01)
・ A USB data-transfer cable (model:ZC9USCBMB1)
・ A commercial USB cable (USB Type A/mini B)
* Possible to send/receive a screen with a SD card, a USB
storage device, or via Ethernet.
*1: This step is required if screen data is saved only in the GP unit, not in any other device
*2: Please use the same version or later as or than that of the software used during creating screens on
GP-377R/377S/377L.
If you don’t know the version, we recommend you to use the newest version. The newest version is
GP-PRO/PBIII for Windows C-Package03 (SP2) V7.29. Those who have GP-PRO/PBIII for Windows
C-Package03 V7.0 can download it from our web site called [OtasukePro!]
(http://www.pro-face.com/otasuke/download/update/).
*3: GPW-CB03 is supported by GP-PRO/PBIII for Windows C-Package02 (SP2) V6.23 or later. You need to
install a driver from [Download] on our Web site called [OtasukePro!]
(http://www.pro-face.com/otasuke/download/driver/)
To Next Page
Loading...
