Pro-face GP-37W3 Series User Manual

Chapter 1 - Introduction
GP-37W3 Series User Manual 1-3
All optional equipment listed below is produced by Digital.Electronics Corporation.
*1 For detailed information about range of connectable PLCs.
Pro-Designer On-line Help


 Available Software


 Tool Connector


 Serial Interface
Product Name Model No. Description
RS-232C cable
*1
GP410-IS00-O
RS-422 cable
*1
GP230-IS11-O
RS-422 cable
Connector terminal
block converter
GP070-CN10-O
Adapter to convert serial data to RS-422
format.
2 Port Adapter II GP070-MD11
Interface unit that allows use of both GP
and Mitsubishi A, Q, C and FX series
equipment in the same location.
2 Port Adapter II Cable GP070-MDCB11 Connects the GP to 2 Port Adapter II.
Mitsubishi A Series
Programming Port I/F
cable
GP430-IP10-O
Mitsubishi FX Series
Programming Port I/F
cable
GP430-IP11-O
Interface cable between the host (PLC)
and GP.
Connects directly to Mitsubishi’s PLC I/F
Programming Console. Simultaneous
use of program console, however, is not
possible.
1.2 Accessories
Product Name Model No. Description
Screen Data Transfer
Cable
GPW-CB02
Connects the GP to a personal computer.
Transfers screen data and user
program(s).
Memory Loader II
GP070-LD01-O
Copies data (system and screen data)
from one GP to another GP. Rev. H or
later
Product Name Model No. Description
Pro-Designer
Ver. 4.0 or later
PS-DWE01-V40
<CD-ROM>
Software to be used to create screen
data using a personal computer.

Pro-face GP-37W3 Series Specifications

General

Brand	Pro-face
Model	GP-37W3 Series
Category	Control Unit
Language	English