3. Identify the Right Upright (76). Have a sec-
ond person hold the Right Upright near the
Base (74).
Tie the wire tie in the
Right Upright (76) securely around the end of the
Upright Wire (63). Then, insert the Upright Wire
into the lower end of the Right Upright as you
pull the other end of the wire tie through the top
of the Right Upright.
74
76
63
76
Wire
Tie
Wire
Tie
3
63
2.
Remove and discard the two screws (A) and the
shipping bracket (B) on the right side of the Base
(74). Then, remove and discard the screws and
the shipping bracket (not shown) on the left side
of the Base.
Next, remove the tie securing the Upright Wire
(63).
Then, press a Base Cap (70) into each side of
the Base (74).
2
B
A
74
Tie
63
70
To Next Page
Loading...
