18
20
26
26
105
F
O
Start First
20. Press the two tabs (not shown) on the Tablet
Holder (105) into the slots (O) in the console
assembly (F).
Then, attach the Tablet Holder (105) with four
#8 x 5/8" Machine Screws (26). Tip: Start the
two upper Machine Screws fi rst, and then
start the two lower Machine Screws. Do not
overtighten the Machine Screws.
IMPORTANT: The Tablet Holder (105) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
21. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the fl oor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see page 31). Note: Extra parts may be included.
To Next Page
Loading...
Need help?
General
