PRO-SYS JetFloss - Operating The Unit; Filling The Reservoir; Flossing With Water Using JetFloss

10
FILLINGTHERESERVOIR
Open the reservoir cover and detach entire reservoir by liing it
up and off the base. Fill with water of desired temperature.
(NEVER use hot or boiling water as it may cause injury and also
damage the unit.) Return the reservoir to the unit and press down
firmly until attached.
FLOSSINGWITHWATERUSINGJETFLOSS
Slide the water intensity control on the wand to its lowest setting.
Direct the tip into sink. Turn the unit’s power on. Lean over the
sink. Place the tip into your mouth and close your lips enough
to prevent water from spraying or splashing. Let water from the
tip flow from your mouth and into the sink. Aim the tip between
teeth and at the gumline, cleaning the areas you would normally
floss. For detailed recommendations, refer to the included
Personalizing Your JetFloss Guide booklet.
AFTERUSE
Empty reservoir of any remaining water and replace onto base.
Direct the tip into the sink and press the power button to turn
the unit on. Operate the unit for a few seconds to flush out
any remaining water in the wand or water tube. Turn power off
when water no longer flows. Remove the tip by pressing the tip
eject button. Unplug power cord. Follow cleaning and storage
instructions on pages 12 and 13.
Operating The Unit
Operating The Unit