PRO-SYS JetFloss - Cleaning And Storage; Important Safety: Moisture and Submersion; Cleaning After Every Use

11
Cleaning And Storage
Cleaning And Storage
IMPORTANT: NEVER EXPOSE BASE TO EXCESS MOISTURE
OR SUBMERGE IN WATER. If it becomes accidentally
submerged, safely disconnect from power source immediately.
DO NOT attempt to operate aer being fully submerged as
damage may have occurred. Always disconnect from power
before cleaning and when not in use.
AFTEREVERYUSE
• Empty reservoir of remaining water and replace onto base.
Direct the tip into the sink and press the power button to turn
the unit on. Operate the unit for a few seconds to flush out
any remaining water in the wand or water tube. Turn power
off when water no longer flows.
• Allow the reservoir to dry completely between uses to avoid
bacteria from forming. If desired, you may thoroughly wash it
with mild soap and warm water and allow to dry completely.
• Thoroughly rinse/flush used tips with water and allow to dry
completely. If desired, wash with mild soap and warm water
and allow them to dry completely.
• Disconnect from power when not in use.