ProBoat Blackjack 26 - Additional Required Items; Building the Boat Stand

4
EN
• Engine Tuning Screwdriver (DYN3048)
• Replacement Glow Plugs (DYN2508 or DYN2500)
• Hex driver/Allen wrench (2.5mm)
• Cable grease to lubricate drive shaft (PRB0100)
• Clean towels
• AA alkaline batteries
• Adjustable wrench (small)
• Extra propellers
In addition to the items needed to run the Blackjack 26 SS, we recommend that you carry the following in your fi eld box:
Although the Blackjack 26 SS comes fully assembled and ready for action, you will need a few tools to get your boat ready to run. You will need
the following:
• Blue Thunder
™
20% Fuel (quart) (DYN2320)
• 500cc Fuel Bottle (DYN2003) or
• Fast Tap
™
Quart Bottle Spout (DYN2009)
• Glow Plug Wrench (DYN2510)
• Ni-Cd Glow Driver (DYN1925)
• 8 AA alkaline batteries (4 for the transmitter
and 4 for the receiver)
• 7.2V Battery (DYN1050) for electric starter
• Battery Charger (DYN4077) for electric starter
1. There are 4 plywood pieces. The 2 short plywood pieces are the
ends of the boat stand.
2. Attach the 2 long plywood pieces of the interlocking boat stand
to the end of one of the short plywood pieces. Repeat with the
remaining short plywood piece.
3. Secure the interlocking boat stand with thick CA or epoxy.
Section 1: Building the Boat Stand
Suggested Field Equipment and Supplies
Additional Required Items