10 of 104 | English
Setting a Turn-On Timer: When the dehumidier is off, press the timer button, then use the
+ and - buttons to set the number of hours before you want it to turn on. The timer light will
illuminate when a timer is set.
Setting a Turn-Off Timer: When the dehumidier is on, press the timer button, then use the
+ and - buttons to set the number of hours before you want it to turn off. The timer light will
illuminate when a timer is set.
Ventilation Mode: Press this button to activate ventilation mode. The corresponding indicator
will illuminate. In this mode, the fan operates without the compressor, circulating air in the
room.
Auto Swing: Press this button to activate the auto swing function. The air deector will
automatically start swinging and creating ows of air throughout.
Sleep Mode: Press the Sleep button to activate the sleep function while the machine is still
operating in any mode. All lights except the sleep light, water full light, and child lock light will
turn off. Press any key in sleep mode to perform functions and wake up the machine.
Child Lock: Press and hold both the Auto Swing and Ventilation buttons for a few seconds
to activate or deactivate the Child Lock function. When the child lock is activated, the LED
displays "LC" and ashes for 5 seconds, then resumes normal display. Pressing other keys in
the child lock state will display "LC" and ash for 5 seconds as a reminder. Pressing the power
button in the child lock state can turn the machine on or off.
Defrost Function: Frost may build up on the evaporator coils, which is normal. When this
happens, the automatic defrost function starts. The compressor turns off, and the fan
continues to run until the frost is removed. The defrosting duration depends on the room
temperature.
Water Tank Full: When the water tank is full, the water full indicator symbol will be displayed,
the buzzer will beep 20 times, and both the compressor and fan will be automatically stopped
after a few minutes.
CONTINUOUS DRAINING
--
To connect the drain hose to the unit:
1. Insert one end of the hose into the continuous drainage hole of the unit. Ensure it is
connected securely.
2. Place the other end of the hose into a bucket or a drain.
3. Ensure the hose is not bent or blocked.
Note: Gravity will pull the water out of the unit into your chosen drainage area. Ensure the
chosen area is not higher than the unit.
EMPTYING THE WATER TANK
--
• When the water tank is full, the unit will make a buzzing sound, and the Water Tank Full
To Next Page
Loading...
Need help?
General
