Main switch –on / off. This is to turn the pump on and off.
Caution! The suction guide line is automatically bled when the VPH is switched off.
For a description of the other elements, please refer to the Appendix: Operating Instructions for
the Battery Diaphragm Pump!
To suction and release the load:
Main Switch ON = suction load, hold
Main switch OFF = release load (remove feet from danger area beforehand!)
Only use suction plates intended for the VPH Vacuum Power Handy.
Never exceed the permitted maximum carrying capacity of the suction plate!
● Do not let go off the handle of the device VPH whilst a load is being lifted..
● Never pull the load diagonally or drag it.
● Do not try to free loads which are stuck using the VPH.
● If there is a power failure, put down the load straight away if possible. Move away from the
danger area immediately.
● Only suction and lift suitable loads (Check for stability and surface density).
● Always keep an eye on the pressure gauge. Never lift a load under - 0,5 bar. If the pointer in
the pressure gauge moves into the red zone below -0,5 bar, put down the load immediately.
● Set down the goods on clear, even surfaces only. Otherwise they could slip when released.
● Only release the load when it is fully and securely standing or lying down.
Keep your fingers away from the load when relevant it to prevent them from
being crushed!
● Always load the suction plates evenly.
To Next Page
Loading...
