Procom ECON-A - Page 4

◦ 1 Phase / 3 Phase Voltage
◦ 1 Phase / 3 Phase Current
◦ Frequency
◦ PF,KW,Kwh & KVA.
◦ Battery Voltage
◦ Water Temperature
◦ Oil Pressure
◦ Fuel Level
◦ RPM
◦ Run Hour
◦ Service Due Hour
• Protection / Supervision Mains
◦ Under/Over Voltage
◦ Under/Over Frequency
◦ Phase Sequence
◦ Voltage Unbalance
◦ Overload
• Protection / Supervision DG
◦ Under/Over Voltage
◦ Under/Over Frequency
◦ Current Unbalance
◦ Over Speed
◦ Overload
◦ RWL
◦ LLOP
◦ HWT
◦ LFL
◦ Charging Alternator/V-belt
◦ Emergency off
◦ Service Due
◦ Fail To Start(only when configured as AMF controllers).
◦ Fail To Stop(only when configured as AMF controllers).
• Digital Input : Eight digital(4 fixed and 4 programmable)
• Analog Input: and three Analog input (sensor measurement)
• Output : Nine digital (five fixed and three programmable) and one for charging Alternator
• Modes : Configurable Auto, Semi auto and manual mode of operation.
• Fault Data Recording : Last 32 fault with date and time stamping
• Event Recording : Last 32 event
• Start Stop Recording: Last 100 records
• Password Protection :Three digit password protection for system settings.
• Real Time Clock (RTC)
• Communication : RS232, USB, RS485(Optinal)
• Timers:: Programmable DG on delay, DG continuous on time, DG rest Time, warm up time along
with 33 other time
• Provision for switching ON or OFF the measurement for individual sensors.
• Option of warning or tripping on sensor open.
• Programmable engine on detection based on ignition voltage, oil pressure build up or on both.
Cat_ECON-06-15 -Ver1.0. Page 4/21