* This parameter can be disabled while programming
13.0 Load Management (Optional)
ECON-A has programmable contact Load management function.
The load management contact will switch on when the current on the generator has crossed a programmed limit
and will reset when the current has fallen below the reset programmed limit. This function can be used to cut-off
unnecessary loads or start a second generator when the load goes above a limit.
14.0 Event Recording
ECON keeps a log of last 32 events. Setting change and warning are considered as event. Events are stamped
along with date and time
15.0 Faults
There are two categories of faults
• Internal Faults
• External faults
Cat_ECON-06-15 -Ver1.0. Page 18/21
To Next Page
Loading...
