Need help?Do you have a question about the ProCurve 2626 and is the answer not in the manual?
General| Switching Capacity | 8.8 Gbps |
|---|---|
| Forwarding Rate | 6.5 Mpps |
| VLAN Support | Yes |
| Layer | Layer 2 |
| MAC Address Table Size | 8000 entries |
| Routing Protocol | Static Routing |
| Enclosure Type | Rack-mountable |
| Subtype | Managed |
| Jumbo Frame Support | Yes |
| Power Supply | Internal |
| Ports | 24 x 10/100 + 2 x 10/100/1000 |
| Management | Web, CLI, SNMP |
Guides on assigning an IP address for network communication and switch setup.
Highlights benefits of the command-line interface for full access and experienced users.
Describes the different privilege levels (Operator, Manager, Global, Context) for access control.
Guides on viewing and reconfiguring switch features using CLI commands.
Provides CLI commands to reconfigure inbound Telnet, web browser, and console/serial link settings.
Details CLI commands for IP configuration, including multinetting and default gateway.
Provides CLI commands to display and configure port status, including brief and config outputs.
Details PoE power availability, PD support, and how the switch allocates power.
Guides on setting power thresholds, priorities, and cycling power on ports.
Guides on using SNMP for managing the switch, including version 1, 2c, and 3.
Details steps for configuring SNMPv3 access, including users, communities, and trap receivers.
Details methods like TFTP, Xmodem, SCP/SFTP, and switch-to-switch downloads.
Provides steps to diagnose and resolve TFTP download failures.
Outlines methods for diagnosing switch problems using web site, LEDs, and topology checks.
Details messages and actions for over-temperature conditions in Series 2800 devices.
Provides steps to diagnose and resolve issues with accessing the web browser or Telnet interface.
To Next Page
