Name: ProCurve 2626
Brand: ProCurve
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Time Protocols

SNTP: Viewing, Selecting, and Configuring

Note that simply selecting a time synchronization protocol does not enable

that protocol on the switch unless you also enable the protocol itself (step 2,

above). For example, in the factory-default configuration, TimeP is the

selected time synchronization method. However, because TimeP is disabled

in the factory-default configuration, no time synchronization protocol is

running.

Disabling Time Synchronization

You can use either of the following methods to disable time synchronization

without changing the Timep or SNTP configuration:

■ In the System Information screen of the Menu interface, set the Time

Synch Method

parameter to None, then press [Enter], then [S] (for Save).

■ In the Global config level of the CLI, execute no timesync.

SNTP: Viewing, Selecting, and

Configuring

SNTP Feature Default Menu

page 9-5 page 9-8 —

CLI Web

view the SNTP time synchronization configuration n/a

select SNTP as the time synchronization method timep page 9-6 page 9-9 ff. —

disable time synchronization timep page 9-6 page 9-12 —

enable the SNTP mode (Broadcast, Unicast, or Disabled) disabled —

broadcast n/a page 9-6 page 9-9 —

unicast n/a page 9-6 page 9-10 —

none/disabled n/a page 9-6 page 9-13 —

configure an SNTP server address (for Unicast mode only) none page 9-6 page 9-10 ff. —

change the SNTP server version (for Unicast mode only) 3 page 9-7 page 9-12 —

change the SNTP poll interval 720 seconds page 9-7 page 9-12 —

9-4

Questions and Answers:

Need help?

Do you have a question about the ProCurve 2626 and is the answer not in the manual?

ProCurve 2626 Specifications

General