Prodigit 3330F User Manual

22 PRODIGIT
Example 2: Once the edit mode has been used to set the 16 step auto-sequence the user
Can press the TEST key. If the test fails at one of the test steps the LCD will flash
“NG” and the test will stop. The user can then press ENTER key to continue the
Test or press the EXIT button to leave the test mode.
TEST MODE
Show Fx
STAR T TEST
1.Pr ess TEST key
2.Pr ess STATE 1~9 Select F 1-F9
Initi al = F1
3.Pr ess ENTER
Test ing(T1)
2.
Ch e ck the G O /NG i n dic a t or
3.
Sto p t e sting if th e r e s ult w as NG .
Exit
1.R e ca l l cor r espon d m e m ory w hich had b e en
sto r ed i n F1- F 9 mem o ry
3.1
Pr e ss ENTE R to b e con t i nu e d.
3.2 Press E XIT to end the test,and back to normal mode.
Ente r/Exit?
Stop
NG ?
Yes
Norm al Mode
End
?
No
Step = Step+1
No
PASS/ FAIL
Show PASS
Show FAIL
PASS
FAIL
2
3
Exit
Yes
4
4.I f t e st is GO,th a n s t ep i s last ?
4. 1 I f no t han S t ep+1 , c on t inue a nothe r s t e p
4.2 If “ Y es” , than if all the test in all m odule is pass, show GO
4. 3 I f
“
Yes
”
, th
ani f ther e is at least one failu re d ur i ng th e
te s t, show N G
5
5 .2 5 .3
5 .1 4 .1
4 .2
ENTER
1
Enter
Norm al Mode
Delay (T2)
Show NG
Fig 3-5 TEST MODE OPERATION FLOW-CHART

Prodigit 3330F Specifications

General

Brand	Prodigit
Model	3330F
Category	Industrial Electrical
Language	English