3302F Series Mainframe Operation Manual 59
[SYStem
：
] RECall{SP}{m}[,n]
Command Syntax:
[ SYStem：] RECall{SP}{m}[,n] {；NL}
Purpose: Recalls the load set-up which has been previously saved in the Memory.
Description: This command is for recalling the procedure stored in a specified
Memory location where:
m = STATE = 1~10
n = BANK = 1~15
If the memory STATE to be used is from the currently selected BANK as shown on
the mainframe’s display then the BANK [n] can be omitted.
For example:
RECALL 2,15
Recalls the load set up saved in the 2
nd
STATE and 15
th
BANK of the memory.
REC 3
Recalls the load set up from the 3
rd
memory STATE from the
current BANK as shown on the units front panel display.
[SYStem
：
] STORe{SP}{m}[,n]
Command Syntax:
[SYStem：] STORe{SP}{m}[,n]{；NL}
Purpose: Saves the Load’s status to the unit’s memory.
Description: This command is for saving the current set up to a specified memory
Location where:
m = STATE = 1~10
n = BANK = 1~15
If the memory STATE to be saved to the currently selected BANK then the BANK [n]
Part of the command can be omitted.
For example:-
STORE 2, 15
Saves the status of the Load to the 2
nd
STATE of the 15
th
memory BANK.
STOR 3
Saves the load setup to the 3
rd
memory STATE of the
current BANK as shown on the units front panel display.
[SYStem
：
] NAME?
Command Syntax:
[SYStem：] NAME? {；NL}
Purpose: Return the model number of unit
Description: This command is for reading the model number of the Load. If no
Module is operating; the display will display “NULL”. The model number will be
Returned as per TABLE 4-12:
To Next Page
Loading...
Need help?
General
