p 30-39. MONO DELAY – Typical echo + feedback effect with decreasing delay times.
p 40-49. STEREO DELAY – Typical echo + feedback effect with ping-pong of left and right channels with
decreasing delay times.
p 50-59. FLANGER – Creates a strong sweeping effect with decreasing times, particularly effective on rock
electric guitar, lead and rhythm.
p 60-69. CHORUS – Provides a soft, ethereal sweeping effect with decreasing times, perfect for
enhancement of electric and acoustic guitar and bass. Also adds a dramatic effect to vocals,
particularly group harmonies and choirs.
p 70-79. DELAY+REV - Typical reverb and echo effect combined together with decreasing times.
p 80-89. FLANGER+REV - Typical reverb and modulation effect combined together with decreasing times.
p 90-99. CHORUS+REV – Typical reverb and modulation effect combined together with decreasing times.
27. FX DISPLAY number
This display shows the number of the currently loaded preset. When rotating the FX selector, the display
scrolls the numbers and flashes until the new preset is confirmed by pressing the FX selector knob.
28. EFFECT MUTE button
Engage this switch if you want to mute the signal outgoing from the internal effect to the MAIN MIX.
29. EFFECT PEAK/MUTE detector
This LED shows 2 conditions:
• always lighted = signals that the effect is MUTED.
• flashing = signals a too high input level, near to the overload of the effect input stage that can cause
audible distortion. In this case, reduce the level of the FX sends.
30. FX FADER level control
It adjusts the level of the internal effect signal sent to the MAIN MIX outputs.
31. AUX 1 SEND level control
It adjusts the general level of the AUX 1 SEND output. This control ranges from off to +15 dB of gain when
fully clockwise.
32. AUX 1 SEND jack output
This jack connector sends out the line-level signal made up of the sum of the input channel’s AUX 1 sends,
usually for connecting to the inputs of an external effect devices or a stage monitor.
33. AUX 2 / FX SEND level control
It adjusts the master level of AUX2 jack output and also the signal sent to internal effect. Use it to reduce the
level of signal sent to the internal effect if the PEAK LED is flashing. This control ranges from off to 15 dB of
extra gain (fully clockwise).
34. AUX 2 SEND jack output
This jack connector sends out unbalanced line-level signals made of the sum of the input channel’s AUX 2
sends, usually for connecting to the inputs of an external effect device or a stage monitor. This signal is post-
fader, or in other words it depends on the position of the channel’s FADER.
To Next Page
Loading...
Need help?
General
