35. MAIN MIX to C.ROOM switch
Push this switch to send the MIX bus signal to C.ROOM and PHONES outputs.
36. GROUP 1-2 to C.ROOM switch
Push this switch to send the GROUP 1-2 bus signal to C.ROOM and PHONES outputs.
NOTE: for a correct operation we suggest to choose these two switches (35) or (36) one at a time.
IMPORTANT: these switches also select which signal is displayed on LED METERS when no channel has the PFL
button engaged.
37. PHONES level control
This controls the PHONES output's level. The signal is selected by MAIN MIX (35) or GROUP 1-2 (36) switches
or by the sum of PFL bus if one or more PFL buttons are engaged.
38. PHONES stereo jack output
STEREO JACK connector for the headphones output: only stereo headphones with a minimum impedance of
32 Ohms should be connected to this output.
39. C.ROOM level control
This controls the C.ROOM output's level. The signal is selected by MAIN MIX (35) or GROUP 1-2 (36) switches
or by the sum of PFL bus if one or more PFL buttons are engaged.
40. C.ROOM L & R jack output
These JACK connectors provide an unbalanced line-level signal that can be used to monitor the signal sent to
C.ROOM.
41. GROUPS 1-2 FADER level control
The GROUP 1-2 FADER control the level of the GROUP 1-2 bus to its outputs or, if "TO MIX" switch is down, to
the MAIN MIX bus.
42. GROUPS 1-2 jack output
These JACK connectors provide a balanced line-level signal from the GROUPS 1-2 stereo bus, controlled by
the GROUPS 1-2 FADER level control.
43. TO MIX switch
This switch assigns the GROUP 1-2 bus to the MAIN MIX bus. As explained earlier, pushing down this switch
you can use the GROUP 1-2 as sub-mix groups, enabling you to control the level of several channels with one
knob.
44. MAIN MIX FADER level control
The MAIN MIX controls the output level just before the MAIN MIX outputs. When the potentiometer is fully
down the MAIN MIX is off, while the "0" indicates a +4dBu nominal output level. Typically, this control is set
near the "0" label and left alone, but it can be used for song fadeouts or quick system-wide mutes.
45. PFL ACTIVE LED
This LED indicates that one or more PFL switches are pressed. The PFL signal bus can be heard through the
C.ROOM/PHONES outputs and visualized on the L & R LEVEL meter.
To Next Page
Loading...
Need help?
General
