Tri Stem
1
INTRODUCTION
Thank you for purchasing this Profile Design Stem. These instructions apply to the Tri Stem.
Please read these instructions thoroughly before attempting to install this item. Proper installation is required for compliance with Profile Design's
warranty policy. If you are not familiar with installation of Aerobars or their accessories, please seek the assistance of your local Profile design dealer
by logging on to www.profile-design.com and using "dealer search" or by calling Profile Design's customer service number p.# 888.800.5999.
Note to Dealers: If you install this product for the consumer, please provide him/her with this owner’s manual after installation.
Tools and materials required:
• Assembly compound such as Finishline Fiber Grip™
• 4mm Allen key
• Torque Wrench with 4mm Hex bit
Your Stem kit should contain:
• One (1) aluminium stem body with two (2) M5x18 steerer clamp bolts
• One (1) aluminium stem faceplate with four (4) M5x18 bolts
• One (1) aluminium headset compression cap with one (1) M6x30 bolt
• One (1) plastic stem cover with two (2) M3x10 bolts
To Next Page
Loading...
