z. Select the mode desired in the following manner:
SCAN- After the monitor is turned on, an arrow will point to the word "Scan". The SPEED,
TIME and DISTANCE modes will be displayed, for about 5 seconds each, in a repeating cycle.
A second arrow will show which mode is currently displayed, Press the Start/Stop key to start
or stop the TIME mode.
SPEED, TIME or DISTANCE- While the SCAN mode is operating (see above), a single mode
can be selected for continuous display. Simply wait until the desired mode is displayed, and
then press the Mode key. The SCAN mode will be cancellea, and _.he sa:a._.'s_ moda ',vii! be
displayed continuously. The SPEED, TIME, DISTANCE and SCAN modes can also be
selected by repeatedly pressing the Mode key.
CALORIE- The CALORIE mode operates whenever the pedals are turned. The numbers
• beneath the display show the number of Calories you are burning per minute. (To calculate the
total number of Calories burned during your workout, simply multiply the number of Calories
burned per minute by the number of minutes you have exei'cised. For example, if you are
burning 6 Calories per minute, and you have exercised for 20 minutes, you have burned a total
of 120 Calories.) Note: Numbers are based on a moderate pedaling resistance level. If you
set the resistance level very high or low, the actual number of Calories burned will be slightly
higher or lower than the number shown.
3. While the TIME or DISTANCE modes are displayed, the display can be reset to zero by pressing
the Mode key and Start/Stop key at the same time. The TIME mode will be stopped after the
display is reset.
4. To turn the monitor off, press the Power key.
MONITOR CARE
Keep the monitor out of direct sunlight or the display may be damaged. Do not allow liquids to come
in contact with the monitor. The monitor can be wiped clean using a soft, dry cloth.
If the monitor does not function properly, the
power and speed wires to the monitor should
be checked. Turn the power off and slide the
console plate off of the bracket on the frame.
Make sure the power and speed wires are
plugged fully into the monitor. If the monitor
still fails to function properly, call the toll-free
number listed on page4 of the owner's
manual. The bike can be used with the
monitor removed, if necessary.
\\ I
© 1990 Weslo, Inc. Printed in U.S.A- Part No. 101044 7/g0
To Previous Page
Loading...
