A10 AirTTL
21
www.profoto.com
Off-camera use
This describes how to operate an A10 unit off-camera and with an
A10 unit on camera as transmitting unit. When A10 is used off-camera
together with an Air Remote on camera, please see instruction manual
for Air Remote how to adjust the flash from on-camera position.
1. Switch on the A10.
2. Turn the dial [13] clockwise to unlock.
3. Turn on Air and select the same radio channel on the A10 unit as
on the transmitting unit on the camera.
4. Select a group on the A10 flash. The unit is now set up for off-
camera use.
5. Take an image to check the exposure or use the test button [12]
and light meter to measure the exposure in manual mode.
6. Adjust overall flash exposure compensation with dial [13] or in
camera menu.
7. To adjust an individual light, select the group on the group
buttons [11] you like to adjust on the transmitting unit and adjust
flash power by rotating the dial [13]. This can both be done in TTL-
and manual mode.
8. In manual mode, the energy setting can also be done on each
unit individually.
When A10 is used as off-camera unit, the TTL/MAN switch [10] will be overridden. The
switch is only valid for triggering an A10 mounted on the camera.
To Next Page
Loading...
