VOLTAGESELECTION (1)
You can choose between two voltage ranges,90-130V,
60Hz or 180-260V, 50 Hz.The generator should be
switched off.Voltage selection is done by pulling out
and turning the plug-in board on the rear panel of the
generator.Youcan see the correct mains voltage on the
top of the card, USE ON … VOLTS ONLY.Makesure
you insert the card STRAIGHT.
MAINS (AC)CONNECTION (2)
The generatoris designed forACconnection only.It can
be connected to the most common mains voltages:
90-130V,60Hz or 180-260V, 50Hz. Before mains
connection make sure that the operating voltage key
card matches (plug-in board) the mains voltage.
When charging the mains voltage the modelling lamp
must also be changed.Connect the unit to the mains
with the cable included in the delivery.
WARNING! Never use ordinaryhousehold extension
cords to extend the power cable.They may overheat.
Contact your Profoto distribution for proper equipment.
CHARGING (3)
Before charging, check that the plug-in board is showing
the correct voltage.The charging time varies somewhat,
depending on the power you selected and the mains
voltage.The charging time isshortestatthelowestpower
andhighestvoltage.You use the switch marked ON to
start charging.The ComPact 600 and 1200Wsare both
equipped with automatic protection (cutout) against
overheating, which switches offcharging.When the
temperature drops, the cutout resets automatically.
This protects the unit against serious faultsthat could
otherwise result from overheating.
ComPact
– English
Profoto 10 The Light Shaping Company
a
b
c
ComPact_Manual_nihav:Pro-7_Manual.final (?)_ny 06-12-05 09.06 Sida 10
To Next Page
Loading...