EasyManua.ls Logo

ProGo 3000 - Starting and Stopping the Engine; Engine Starting Instructions; Engine Stopping Instructions

Default Icon
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
SECTION 8: STARTING & STOPPING THE ENGINE
8.1 ENGINE STARTING INSTRUCTIONS
8.2 ENGINE STOPPING INSTRUCTIONS
1.Checktheoillevelinthecrankcase(seesection9.1)
2.Placeunitfirmlyontheground.Donotattempttostartnearpilotlightsoranyopenflame.Do
notsmoke.Graspthestarterropehandlewithonehandandthethrottlewiththeother.
3.Withtheunitinthestartingposition,pulltheropesmoothlyandbriskly.Theengineshould
startwithin3-5pulls.Oncewarm,theengineshouldstartonthefistpull.
NOTE:Onthefirstuse,itmaytakeextrapullstofillthefuelsystemwithpropane.
4.Squeezethethrottlecontrolslightlytowarmuptheenginefor15to30seconds.Incold
weather,movethethrottleslowlyuntiltheenginewarmsupfor30to60seconds.
NOTE:Whenstartingtheengineinveryhotorcoldconditionsitmaybenecessarytosqueeze
thethrottleopenwhilepullingthestarterrope.
1.Releaseyourhandfromthethrottlecontrollever.Allowtheenginetocooldownbyidling30to
60seconds.
2.Pressandholdtheenginekillbuttonuntilenginestops.
3.Whendoneusingtheunitfortheday,disconnectthepropanecylinderandproperlystoreit
awayfrompilotlights,flames,sparks,orotherheatsources.Keepoutofreachofchildren.
WARNING: The exhaust contains chemicals known to the state of California
to cause cancer, birth defects or other reproductive harm.