ProGo 3000 - Adjustments; Brake Adjustments

18
SECTION 11: ADJUSTMENTS
11.1 BRAKE ADJUSTMENTS
11.2 WHEELS
11.3 TIRES
Disc brake caliper:Thebrakecalipermustbereplacedwhenthebreakpadsareworndownto
lessthanthethicknessofadime.
Adjustment:
1.Adjustthegapbetweenrotorandoutsidepadwith3mmAllendriverviathecenterholeof
caliper,turnclockwisetomovepadforwardandcounterclockwisetomovepadback.
2.Adjustgapbetweenrotorandinsidepadwith5mmAllendriverviacenterboltonbackcover.
Turnclockwisetomovepadforwardandcounterclockwisetomovepadback.
Replacing worn pads:
1.Removethecaliperfromforkusing5mmAllendriver(bothbrakeleveradjustmentsbarrels
needtobescrewedallthewayin).
2.Usepointednosepliersorscrewdrivertoremovesafetyclipfrompadguide.
3.Loosenpadguildscrewwith3mmAllendriver.
4.Removecompletepadassemblywithinnerplatespring(carefulnottobendortwistspring).
5.Fitreplacementpadontospringplate.
6.Insertpad/springcombinationintopadslotandrelocateguidescrew.
7.Fastenguidescrewandpushsafetyclipbackintoclipgaponguidescrew.
8.Adjustbrakesasdescribedinthemechanicalsafetychecksection.
Maintenance of disk brake caliper: Keepallsurfacescleanandfreeofoilanddebris.More
detailedinformationavailableatwww.progoscooters.com
Brake lever and cable:Makesurethecableisnotfrayedorkinkedinanywayandcheckthat
thecablehousingendsaresecurelyseated.Anadjustmentisavailableatthebrakes;youcan
increaseortakeupslackbyscrewingorunscrewingtheadjustmentbarrel.
Front wheel removal:
1.Makeanoteofthelocationforthewashersusedonthefrontaxle.Usepointednosepliersor
screwdrivertoremovesafetyclipfrompadguide.
2.Removetheaxlenut.
3.Slidetheaxleboltoutandremovewheel.
Rear Wheel Removal:
1.Makeanoteofthelocationforthewashersusedonthefrontaxle.
2.Removetheaxlenut.
3.Slidetheaxleboltoutandremovewheel.
NeverusetiresortubesthatarenotrecommendedbyPROGO®orthatexceedthemaximum
P.S.I.limitsofthetireassemblyinuse.
Incaseyoucannotreachthetirevalvewithyourpump,usetheinflationextensionadapter
(includedinthepackaging)toinflatethetires.
CAUTION: In order to help keep your unit functioning normally, have any
repair or maintenance which is not specifially described in this manual
performed by an authorized PROGO® dealer.