Rev: 05.21.18 Page 2
EuroLoft™ Bed Lift (Overhead) OEM
Safety Information
Important Information
• Safety devices shall not be tampered with for any reason.
• It is strictly forbidden to be on the bed lifting system while it is being operated.
• Do not interfere with the bed lifting system while operated, neither with any objects or with hands.
• Before starting the vehicle engine and driving, always make sure the bed lifting system is in its highest
position and the safety belts are fastened (excluding garage bed).
• Do not operate the system improperly (e.g. with people on it).
• The bed lifting system shall only be used by adults and responsible staff.
• It is forbidden to use the bed lifting system while the vehicle is running.
• Do not move the bed lifting system if people or animals or items are around, under or on it.
• The bed lifting system must never be used while the vehicle is running.
• It is forbidden to start the bed lift system manually with disconnected wires from motor unit to control unit.
• Should the mechanism not work, do not use the bed and ask for assistance at the next service center.
TABLE OF CONTENTS
Safety Information 2
Important Information 2
Resources Required 3
Prior to Installation 3
Unpacking the Bed Frame 3
Motor and Motor Bracket 4
Power Controller 5
ACS Module Holder and Bracket 5
Stabilizer Guide Track Bracket and Roller Assembly 6
Installation 6
Belt Mounting Brackets 6
Stabilizer Channel Guides 8
Euroloft Switch 8
Wiring Harness Connections 9
Wire Harness to Components 9
Wiring Diagram 10
Setting the ACS Stop Procedure 11
Operation 12
Prior to Operating the EuroLoft Bed Lift System 12
Lowering the Bed Lift 12
Raising the Bed Lift 12
Manual Override 13
Maintenance 13
Failure to act in accordance with the following may result in death, serious injury or property
damage.
Moving parts can pinch, crush or cut. Keep clear and use caution during assembly.
To Next Page
Loading...