3
PRODUCT SPECIFICATIONS
Maximum ow rate: 1.8 GPM (6.8 LPM) at 60 PSI Ceramic cartridges
ASME A112.18.1/CSA B125 Manufactured to include no more than 0.25%
weighted average lead content on wetted
surfaces
NSF/ANSI/CAN 61: Q ≤ 1
21-K822-PSD – Chrome nish
21-K822-PS-SSD – Stainless steel nish
21-K822-PS-ORBD – Oil rubbed bronze nish
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
CAUTION
• If you solder the joints during installation of the faucet, the seats, cartridges and washers must be
removed before using a ame or the warranty will be voided on these parts.
• Cover the sink drain to avoid losing parts.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water supply lines.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service for replacement parts. You could also contact us at
partsplus@lowes.com or visit www.lowespartsplus.com.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable Wrench, Slip Joint Pliers, Pipe Wrench, Phil-
lips Screwdriver, Silicone, and Supply Lines.
Installation may vary depending on how the previous faucet was installed. Supplies necessary
for the installation of the faucet are not all included; however, they are available wherever plumbing
supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn on the old faucet to
release built-up pressure. When installing the new faucet, hand tighten the connector nuts. DO
NOT OVERTIGHTEN. Connections that are too tight will reduce the integrity of the system.
To Next Page
Loading...
